1. Power transmission. Close the air switch in the control cabinet, the power indicator light of the mesin slitting line is on, pay attention not to touch the terminal with your fingers, be careful of electric shock, which will endanger safety.

2. Upper curtain roll. Open the guide safety clip, hang the curtain roll, close the safety clip, separate the curtain and adhesive tape, and wind the curtain onto the take-up drum.

3. Artificial adhesive tape. Turn the guide to manual, turn forward and jog the guide, and manually drag the adhesive tape through the correction roller, tension roller, brake roller, and drive roller.

4. Draw the thread. Cut the rubber strip with scissors according to the size of the rubber strip to be produced, then draw the thread and fix it on the thread-drawing roller.

5. Upper curling roller. Remove the square shaft at the end of the winding shaft, install 30 nylon reels, and then install the upper shaft, open the winding safety chuck, and install the winding shaft. The operation of winding 1 and winding 2 is the same.

6. Tape the cloth head. Stretch the rubber strip to a suitable position, wind the rubber strip on the reel, and pay attention to keep the length of the rubber strip consistent to keep the tension of the rubber strip consistent.

7. Adjust the tension. Adjust the coiling tension to 6.5-10, and adjust the unwinding tension to 10-15. Note that as the coiling diameter increases, the coiling tension increases appropriately to ensure that the strip tension is consistent.

8. Adjust the coiling speed. Adjust the take-up speed within the required range. Note that the take-up speed should not be too high when starting to avoid deviation correction and tracking errors. It can be adjusted to 20 and then increase the speed after starting.

9. Start the machine. After the above operations are completed, press the start button, and after one or two rotations, observe whether the rubber strip of the reel is misaligned. If so, stop winding, adjust the position, and continue to rotate. At the same time, pay attention to the position of the thread head to adjust the start and stop of the thread to prevent the thread from being broken or pinched.

10. Adjust the tightness of the coiling strip. If there is looseness of the rubber strip, it is generally due to the thickness of the rubber strip, which leads to a smaller coiling diameter, which can be increased by adding a plastic pad to increase the diameter, so as to ensure that the tension is consistent with other rubber strips.

11. Stop the machine after coiling is completed. Stop the machine when the crimp diameter reaches 160 mm.

12. Remove the product. Cut off the adhesive strip, loosen the safety clip, lift down the take-up shaft, take the lower shaft, unload the product, pay attention to separate the product in time, do not stack them together, and prevent them from sticking together.

13. Prepare for the next coiling.

14. If the machine is not used for a long time, please turn off the main power of the machine.

We Are Slitting Machine Manufacturer

BANGZHOU Machinery is a mesin slitting line manufacturer that specializes in the production of high quality machines. Our machines are used in a variety of industries, including the metal and aluminum sheet industry. We have a team of experienced engineers who are dedicated to create machines that are durable and easy to operate. We also have a team of customer service representatives who are available to answer any questions you may have about our products.