Feed pellet machine is an indispensable and important equipment in the feed production process. Proper feed grinding machine maintenance and care can not only ensure its efficient operation, but also extend the service life of the equipment. The following are the key factors to extend the service life of feed pellet machine.

1. Regular cleaning and inspection
During the operation of feed pellet machine, some impurities and oil stains will accumulate. If these impurities are not removed in time, they may affect the normal operation of the machine. Therefore, after each use, the equipment should be cleaned in time, especially the feed inlet, discharge port, screen and mold part to avoid blockage or corrosion. Regularly check the wear of various parts of the equipment, such as molds, rollers and screens, and replace them in time if problems are found.

2. Lubrication and maintenance
Friction between mechanical parts is one of the main causes of equipment wear. Regularly lubricate the moving parts of the feed pellet machine, especially bearings, gears and transmission systems. This can not only reduce friction and improve the efficiency of equipment operation, but also avoid excessive wear. Lubricating oil that meets the requirements should be used, and the oil should be replaced according to the manufacturer's recommended cycle.

3. Control load and temperature
When using the feed pellet machine, make sure that the equipment works under the appropriate load and avoid overload operation. Overload will not only increase the burden on the machine, but may also cause overheating or equipment damage. At the same time, check the temperature of the equipment regularly to ensure that the equipment operating temperature is within the normal range. Excessive temperature may cause motor damage or oil deterioration, which will affect the normal use of the machine.

4. Regular calibration and adjustment
Over time, the components of the feed pellet machine may deviate due to use, affecting its performance. For example, the gap between the roller and the die may gradually increase, resulting in uneven pellet production. Regularly calibrate the equipment and adjust it as needed to ensure that the working condition of each component is within the optimal range.

5. Reasonable storage
When the feed pellet machine is not used for a long time, it should be stored in a dry and ventilated environment to avoid the intrusion of moisture and dust, and prevent rust or corrosion. During storage, the equipment can be treated with anti-corrosion, and the storage status of the equipment can be checked regularly to prevent component damage caused by long-term idleness.

6. Avoid frequent start and stop
The feed pellet machine should try to avoid frequent start and stop when working, because frequent start and stop may cause unnecessary damage to the motor and other components. In order to reduce this situation, it is recommended to plan the production process reasonably to ensure the continuous operation of the equipment.

In general, the maintenance and care of the feed pellet machine is the key to ensure its long-term stable operation and extend its service life. Through regular cleaning, lubrication, inspection and adjustment, equipment failures and wear can be minimized, production efficiency can be improved, maintenance costs can be reduced, and the long-term stability of the equipment can be ensured.